BAR HARNESS II - CANYON DANCER

BAR-HARNESS II

Bar-Harness II has a glass-filled injection-molded polycarbonate "cup" to replace the old handlebar "cuff"

Eliminates possible damage to soft grips and holds the cross straps farther away from the switchgear

Sized to fit the widest grips on the market

Uses a heavier thread with more stitches to provide greater strength

Made in the U.S.A.

STRAP WRAPPERS

Slip over tie-down hooks; prevent strap rash and buckle bruise

Fit both the Bar-Harness and Bar-Harness II

Measure approximately 12" L x 1 1/2" W

Available in black; sold in pairs

Made in the U.S.A.

Warning:

NEVER start engine with harness installed.

NEVER install harness on loose or bent bars.

NEVER install harness on any part of the motorcycle except the grips at the ends of the bars.

NEVER install harness on handlebars higher than four inches above the top triple clamp or handlebar clamp except as additional stabilization.

NEVER leave the harness installed on rubber mounted bars for an extended length of time (weeks) except when used as an additional stabilizer and other tie-downs are used to support the total weight of the motorcycle.

NEVER compress the front forks more than halfway or approximately two to three inches.

NEVER pull down on the straps hard enough to bend your handlebars or your bar-end weight bolts. Extra caution should be used when using ratchet tie downs.

NEVER install the harness on motorcycles with extended forks (such as choppers).

These warnings are for our protection! Don’t ignore them and blame problems on the harness.